|
|
|
| We are very sorry for any inconvenience
we have caused. Because of allot of spam we have
been unable to received any emails between March -
July. We have updated our web page and have
updated email system. We are taking orders again
at this email address.
Orders:
support:
|
|
| |
 |
Fully
Made Interface Kit v3.5 - $150.00
Non-Profit Price $99.00
Comes with Interface,
Sensors, Ribbon Cables, and Software.
This fully made kit will include
everything you need to connect your track up to the
computer. The only thing I do not supply in this
package is the Light bar (not available from me) and the
Serial Cable. If you would like you can purchase
Serial Cables from me. (below) |
|
| |
$10.00
- Replacement Sensors
A cable kit of
6 sensors for either top or bottom of track.
Used for replacement sensors at
both the top or bottom of the track. Used to detect
the car. You would only need the replacement sensors
in case the ones that you have somehow got messed up during
install or if you where unable to build your own. One
pack of 6 sensors per kit!
(comes with Fully Made Interface) |
 |
|
| |
 |
Replacement
Cables
Each Track setup will need
two serial cables. One from the computer to the end of
the track and another from the computer to the top of the track.
Because the length is based on the track size, you will need
to contact me for a price on the cables.
The following come
with the Fully Made Interface:
6" Parallel Ribbon Cable - $5.00
6" Sensor Ribbon Cable - $5.00
6' Gate Release Cable - $2.00
|
|
| |
| $20.00
- Circuit Board v3.5
Get a Circuit board if you would
like to just purchase the software and build your own
interface from scratch! Grate
project for the Pathfinders to get there Electronics Honor. |
 |
|
| |
 |
PineWood
Racer v3.70 - $50.00
CD-Rom for Dos, Windows 3.x, 95, 98, and ME
The software comes with full schematics
and parts order list for your local radio shack if you would
like to purchase the parts yourself and build everything
yourself. |
|
Will soon add full Part's Kit, Parallel ports, and Barcode
Readers to list. Note 1: The prices are for
"non profit" clubs, groups, or churches only.
Note 2: I DO NOT supply the hardware for the derby
track. Such as the parts to make the track, glue, paint, or any
other device that is not directly connected to my interface. I
also do not supply the latch device that may be used to drop the gate or
hold the gate in place. Nor do I supply the needed parts to build a
light bridge over the track.
Note 3: Shipping charges are not included
in pricing. Shipping charges will be calculated at time of order!
|
|
